Good day,
I am attempting to diagnose and repair a Lamona Dryer, model FLM8800.
The issue was with the water pump that failing has burned some component on the PCB module.
The control board is labeled as CTI-600 and TBM-CEM1. It also features an E.G.O TDP FMBC module (Article Number: 32035234, Lamona SKU: A22124384, priced at £80).
In the attached images, where seems to be clear where the issue is, there are two specific components I am struggling to identify:
A transistor
A second component adjacent to the transistor, which appears to be a capacitor or possibly a diode.
Could anyone provide insight into what these components might be? If you have experience with this board or know where a schematic or service manual for this board might be available, your guidance would be invaluable. I suspect the transistor could be a standard switching type, such as a MOSFET or BJT, but I am unsure of its exact specifications. The second component resembles a capacitor, but I would appreciate confirmation or correction.
I have already contacted Lamona support, but I am exploring all avenues to make the repair more economic and ovoid waste.
Thank you in advance for any assistance you can provide.
For anyone looking for the same, I have another board:
Marked as “000”: This is a zero-ohm resistor, often used as a jumper to connect traces on the PCB.
Marked as “103”: This indicates a 10 kilo-ohm resistor (10 followed by three zeros).
Marked as “195”: This indicates a 1.9 mega-ohm resistor.
Marked as “106”: This indicates a 1 mega-ohm resistor (10 followed by six zeros would be 10,000,000 ohms, but typically, 106 is used to denote 1 mega-ohm).
This one I don’t know :-)