I’m reviving an old Yamaha XV535 Virago. It’s running and passed roadworthy inspection yesterday, but it has one remaining issue before I take it for a real ride - its not charging enough. Battery voltage increases from ~12.5V to ~12.9V when I start it. Should be ~14V.
A lot of the electrical connections were very crusty - I’ve cleaned them as best I can with contact cleaner and mechanical scraping. The 4 pin connector from the pickup coils to the loom was particularly nasty and has been hot and I could not clean it enough so replaced it with a (knock-off) Deutsch DT connector and that’s working well. The connector from the stator to the loom has also been hot. I’ve replaced the plastic shells and cleaned the connectors as best I can but I feel this connector may still be the source of my low charging voltage and I plan to replace it.
My options are 3 x generic bullet connectors or a single 3 (solid) pin Deutsch DT.
I know the DT connectors are not intended for “power” applications, but I can’t find anything to say if the current on each of these wires from the stator would exceed the ~7.5A they are supposed to be rated for.
Thoughts?
Are you sure 12.9 isn’t ok? It is charging if the voltage goes up… but also yamaha’s of this vintage (sorry I don’t actually have one, so I’m just guessing) probably have a 6 wire rectifier, which should sense the battery voltage and stop charging when the battery is healthy and full.