Used the same 3D model files as the other folding keyboard I made recently. That one was for work. I really liked the layout and size and wanted to make the same thing for home. The main things I wanted to change were:
- I don’t need it to fold since I’m not going to be carrying it around at home. It will just be sitting on my desk.
- Thought I would try to make this one wireless and cut down on the number of cables across my desk.
So I merged the 2 halves of the 3D model for the wireless version and ordered a Nice Nano v2 clone and a battery to make this a bluetooth keyboard. I actually like having a gap in the middle even when there’s no folding hinge, so I kept that and put a small battery isolating switch in the middle.
Final thoughts:
- ZMK Studio really sucks compared to VIAL.
- The Nice Nano clone reports battery level to CachyOS, but I think the reading is completely inaccurate.
- Macros take much longer to send over bluetooth and I’m even happier with my choice of going for a wired build for the work version.
This time I’ve done some calculations for how much this cost:
- My time to make this one: 8.5 hours
- Cost of all parts and commissioned 3D modelling for both keyboards combined: £261.57 for 2 keyboards. So by this calculation I’ve spent £130.79 per keyboard.
- If we remove the cost of the commission and divide to the cost to the number of pieces used out of a multipack, then this specific keyboard cost: £66.68
- Sense of pride and accomplishment: -£1,000,000,000





The 2 flat screws in the middle at the back are connected to the reset pads on the microcontroller. If i short these with a paperclip then the Nice Nano goes into bootloader mode to flash an updated firmware, or a reset .uf2 if I want to clear the stored bluetooth pairings:

Very nice looking!


