Left: I opened a sealed roll of a filament purchased in 2018 and I printed that rose

Right: I dried that filament in the creality dryer overnight and sent the print again

This pic was taken on 10th April. After drying the filament I put it back in storage and I forgot about it until it exploded today

  • colourlesspony@pawb.socialEnglish
    1·
    5 months ago

    I live in southern AZ where it is super dry. I never thought I needed a filament dryer. I got one anyways and it turns out I did need one. My print are so much better now. Would recommend.

  • dmention7@lemm.eeEnglish
    1·
    5 months ago

    It’s crazy easy too. You can get a decent size plasric tote with weatherproof gasket for about $15-20, and a few packs of reusable dessicant packs will.run another $10-15.

    For about $30 all in you can keep 6-8 rolls of filament below 10%RH full time with zero hassle.