nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 28 days agoWhat is the problem here?imagemessage-square27linkfedilinkarrow-up137arrow-down10
arrow-up137arrow-down1imageWhat is the problem here?nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 28 days agomessage-square27linkfedilink
minus-squareBonje@lemmy.worldlinkfedilinkEnglisharrow-up2·edit-228 days agoAdhesion and bedmesh calibration should solve the explosions/under extrusion in far back. The stringiness/ bad line-line adhesion is from bad z level calibration.
Adhesion and bedmesh calibration should solve the explosions/under extrusion in far back. The stringiness/ bad line-line adhesion is from bad z level calibration.