nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 9 days agoWhat is the problem here?imagemessage-square27linkfedilinkarrow-up137arrow-down10
arrow-up137arrow-down1imageWhat is the problem here?nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 9 days agomessage-square27linkfedilink
minus-squareJoelk111@lemmy.worldlinkfedilinkEnglisharrow-up2arrow-down1·7 days agoIn some places it’s too close, but in many places (like the top) it’s way too far away.
minus-squareRichard Wonka@slrpnk.netlinkfedilinkEnglisharrow-up1·6 days agoIt may have a probe levelling grid active that’s out of whack.
In some places it’s too close, but in many places (like the top) it’s way too far away.
It may have a probe levelling grid active that’s out of whack.