Back in the day the anywhere between was a lot smaller.

Yes, it would make for an interesting follow up article.

Too bad the interview doesn’t go into what is some good starting gear to get into hardware modding.

Back in the day Tasker was the ultimate automation app. Don’t know how it has aged.

If don’t care about open source or that you’re locked into a vendor specific slicer. The A-series from Bambu labs is a very good turn key printer.

If you care about the specifics of open source or how your print gets sent to the printer, then I suggest looking somewhere else.

Sounds like something that could be automated via home assistant and an esp32.

Just ask Anakin