Used the same 3D model files as the other folding keyboard I made recently. That one was for work. I really liked the layout and size and wanted to make the same thing for home. The main things I wanted to change were:

  • I don’t need it to fold since I’m not going to be carrying it around at home. It will just be sitting on my desk.
  • Thought I would try to make this one wireless and cut down on the number of cables across my desk.

So I merged the 2 halves of the 3D model for the wireless version and ordered a Nice Nano v2 clone and a battery to make this a bluetooth keyboard. I actually like having a gap in the middle even when there’s no folding hinge, so I kept that and put a small battery isolating switch in the middle.

Final thoughts:

  • ZMK Studio really sucks compared to VIAL.
  • The Nice Nano clone reports battery level to CachyOS, but I think the reading is completely inaccurate.
  • Macros take much longer to send over bluetooth and I’m even happier with my choice of going for a wired build for the work version.

This time I’ve done some calculations for how much this cost:

  • My time to make this one: 8.5 hours
  • Cost of all parts and commissioned 3D modelling for both keyboards combined: £261.57 for 2 keyboards. So by this calculation I’ve spent £130.79 per keyboard.
  • If we remove the cost of the commission and divide to the cost to the number of pieces used out of a multipack, then this specific keyboard cost: £66.68
  • Sense of pride and accomplishment: -£1,000,000,000

The 2 flat screws in the middle at the back are connected to the reset pads on the microcontroller. If i short these with a paperclip then the Nice Nano goes into bootloader mode to flash an updated firmware, or a reset .uf2 if I want to clear the stored bluetooth pairings:

  • cRazi_manOP
    link
    fedilink
    English
    arrow-up
    1
    ·
    6 hours ago

    Hadn’t seen the Gherkin design before. What’s that like to type on?

    I’ve found that there are plenty of people on Facebook Marketplace who will make 3D prints and post them over pretty cheap. Works out well for me because the process of getting a good print takes plenty of learning too.