cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 3 months agoPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.ioexternal-linkmessage-square17linkfedilinkarrow-up165arrow-down12
arrow-up163arrow-down1external-linkPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.iocm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 3 months agomessage-square17linkfedilink
minus-squarenickwitha_k (he/him)@lemmy.sdf.orglinkfedilinkEnglisharrow-up2·3 months agoMy suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.
My suspicion would be that belt printers were not in the scope when writing it. Probably a good idea to open an issue in GitHub so that they can fix it.